GE GTW330

56 pages

To Next Page

To Next Page

Loading...

WASHERS

SAFETY INSTRUCTIONS ..........3

USING THE WASHER

Getting Started ...................... 5

Loading .............................15

Appliance Communication .............16

CARE AND CLEANING ............17

INSTALLATION

INSTRUCTIONS

.....................18

TROUBLESHOOTING TIPS ......23

LIMITED WARRANTY ............27

CONSUMER SUPPORT .......... 28

OWNER’S MANUAL &

INSTALLATION

INSTRUCTIONS

Write the model and serial

numbers here:

Model # _________________

Serial # _________________

You can find them under the

lid of the washer.

ENGLISH/ESPAÑOL

GE is a trademark of the General Electric Company. Manufactured under trademark license.

GTW540

GTW525

GTW500

GTW490

GTW485

GTW480

GTW465

GTW460

GTW340

GTW335

GTW330

GTW220

HTW240

HTW200

49-3000255 Rev 2 08-21 GEA

G033

Table of Contents

Other manuals for GE GTW330

Questions and Answers:

C
craig37Aug 23, 2025
What to do if my GE GTW330 is leaking water?
- P
  pamelarobinsonAug 25, 2025
  If your GE Washer is leaking water, there are several potential causes. First, ensure you are using the correct amount of High Efficiency detergent. Using too much detergent, especially in soft water, can cause leaks. Also, check that the fill and drain hoses are tightly connected to the faucets and the drain facility, and that rubber washers are properly installed. A clogged household drain could also be the culprit, potentially requiring a plumber. Ensure the drain hose isn't rubbing against the wall, which can cause wear. Finally, ensure the hoses are tightened at the faucets and inspect the fill hoses for damage; replace them every 5 years.
N
nicholaswalshSep 1, 2025
What to do if there is low water flow in my GE GTW330?
- S
  Stacy MooreSep 1, 2025
  If you're experiencing low water flow in your GE Washer, the water valve screens might be clogged. Turn off the water supply and disconnect the hoses from the back of the washer and the faucets. Clean the hose screens and the screens in the machine using a brush or toothpick. Reconnect the hoses, turn the water back on, and check for leaks.
J
Jessica GonzalesSep 1, 2025
Why does the water level seem low in my GE Washer?
- V
  Vicki LarsenSep 1, 2025
  If the water level seems low in your GE Washer, it's likely normal. This high-efficiency washer is designed so that water may not cover the top level of the clothes.
V
Victoria SanchezSep 2, 2025
How to deal with a small amount of water remaining in the dispenser of GE GTW330 Washer?
- D
  David EllisSep 2, 2025
  It is normal for a small amount of water to remain in the dispenser of your GE Washer after the cycle.
M
Michael WilsonSep 3, 2025
Why is there lint or residue on my clothes after washing in my GE GTW330 Washer?
- B
  Benjamin CastilloSep 3, 2025
  If you're finding lint or residue on your clothes after washing in your GE washer, several factors could be at play. If you air dry your clothes, they may retain more lint. Ensure you're separating lint producers from lint collectors during washing. Avoid washing loads for too long; use the Light Soil setting for smaller loads and consider using a liquid detergent with warmer water to help detergents dissolve better. Overloading the washer can also cause this issue, so load clothes loosely around the outside of the basket. Finally, check the fabric softener package for instructions, ensure correct usage, and select the Deep Rinse option if available.
M
Marcus PierceSep 4, 2025
Why are my clothes too wet after washing in my GE Washer?
- K
  Kimberly HunterSep 4, 2025
  If your clothes are too wet after washing in your GE washer, it could be due to selecting the wrong cycle for the load you're washing. Also, some fabrics might feel wetter when rinsed with cold water. If the wash load is out of balance, redistribute it and run the Drain & Spin cycle.
P
Phillip RushSep 4, 2025
Why are there colored spots on my clothes after washing in my GE Washer?
- J
  Jamie JohnstonSep 4, 2025
  Colored spots on clothes after washing in your GE washer can be due to incorrect use of fabric softener or dye transfer. Check the fabric softener package for instructions, follow directions for using the dispenser, and ensure you've selected the Deep Rinse option, if available. Sort whites or lightly colored items separately from dark colors to prevent dye transfer.
B
bentonrobertSep 5, 2025
Why are there snags, holes, tears, rips or excessive wear on my clothes after washing in my GE GTW330 Washer?
- T
  Tyler WoodSep 5, 2025
  Snags, holes, tears, rips, or excessive wear on clothes after washing in your GE washer can occur due to: * Pins, snaps, hooks, sharp buttons, belt buckles, zippers, and sharp objects left in pockets. Fasten snaps, hooks, buttons, and zippers. Remove loose items like pins, objects in pockets, and sharp buttons. Turn knits (which snag easily) inside out. * Undiluted chlorine bleach. Check the bleach package instructions for the proper amount and never add undiluted bleach to the wash or allow clothes to come into contact with undiluted bleach. * Chemicals like hair bleach or dye, or permanent wave solution. Rinse items that may have chemicals on them before washing and use the Speed Wash cycle with the Extra Rinse option (on some models).
E
earlvillegasSep 6, 2025
Why is the water temperature incorrect in my GE GTW330?
- M
  Mark WalterSep 6, 2025
  If the water temperature in your GE Washer seems incorrect, first ensure that both hot and cold water faucets are fully turned on and that the hoses are connected to the correct faucets, noting the “H” and “C” markings on the water valves. Check the water valve screens for blockage by turning off the water source, disconnecting the hoses, cleaning the screens with a brush or toothpick, reconnecting the hoses, and turning the water back on, ensuring no leaks. Finally, verify that your house water heater is set to deliver water between 120°F and 140°F (48°C–60°C).
L
Laura PayneSep 7, 2025
Why are my clothes grayed or yellowed after washing in my GE Washer?
- T
  theresaosbornSep 7, 2025
  If your clothes are grayed or yellowed after washing in your GE Washer, ensure you are following the detergent manufacturer’s directions for the amount to use. If you have hard water, use a water conditioner or install a water softener. Make sure your water heater is delivering water at 120°F–140°F (48°C–60°C). Avoid overloading the washer; loosely load clothes no higher than the top row of holes in the washer basket, loading items around the outside for best results. Sort clothes by color, especially if the fabric label indicates that unstable dyes may be present.

GE GTW330 Specifications

General

Brand	GE
Model	GTW330
Appliance Category	Washer
Washer Type	Top Load
Color	White
Number of Wash Cycles	12
Maximum Spin Speed (RPM)	700
Agitator	Yes
Energy Star Certified	No
Voltage	120V
Width	27 in.
Depth	27 in.
Height	44 in

Summary

Important Safety Information

Proper Disposal of Your Appliance

Instructions for environmentally safe disposal or recycling of the appliance.

Proper Installation and Start-Up

Guidelines for correct installation, including electrical safety and start-up sequence.

Using the Washer

Getting Started

Initial steps and overview of the washing machine controls and features.

Wash Cycles Guide

Loading

Proper Detergent Use and Sorting

Installation Instructions

Before You Begin Installation

Location and Setup Procedures

Water and Drain Connections

Instructions for connecting the water supply hoses and the drain hose correctly.

Electrical Requirements and Final Checks

Information on electrical connections, grounding, and a final checklist before operation.

Troubleshooting Tips

Before You Call for Service

Common problems and their possible causes and solutions to help resolve issues.

Limited Warranty

GE Washer Limited Warranty Details

Overview of the warranty period, what is covered, and replacement policies.

Warranty Exclusions and Limitations

Related product manuals

GE GTW330ASK_WW

GE GTW335ASN2WW

Preview: GE GTW750

Preview: GE GTW680

Preview: GE GTW755

Preview: GE GTW540

Preview: GE GTW490

Preview: GE GTW460

Preview: GE GTW485