GE GTW750CSLWS - Page 32

– 32 –
Fault
Code
Fault Name Description Repair Action
25 Pressure Sensor
Dropout
1. Disconnected pressure hose.
2. Pressure tube is pinched or has water
in it.
3. Pressure sensor fault.
 Check pressure tube for
pinches where it goes through
top cover grommet.
 Check pressure tube for
trapped water.
 Check for any leaking water
valves.
 Check home water pressure.
 Check the output voltage from
the pressure sensor to ensure
it matches the water level in
the basket according to the
pressure sensor chart.
26 Out of Balance
(OOB) Ended Final
Spin
Washer could not redistribute load to
HOLPLQDWH22%FRQGLWLRQWRDFKLHYH¿QDO
targeted spin speed.
 Manually rebalance the load,
check basket for damage, and
run a
Drain & Spin cycle.
 If washer spins properly, talk
with consumer about loading.
 If the washer will not spin
properly, check the balance
ring, the rod and spring
assemblies, the speed sensor,
and the speed sensor harness
for proper operation.
27 Water Accessibility This will happen during a cycle if water is
left in the tub with the lid open more than 15
minutes.
 Check for leaking water valves.
 Use pressure sensor test
10 to ensure correct sensor
operation.
 Consumer education on leaving
the lid open for more than 15
minutes during a cycle.
 Can be caused by selecting the
no spin option.
28 Option Knob
Feedback Invalid
This fault is set if a cycle is running and an
invalid knob position is detected.
 Make sure knobs are in a valid
position.
 Ensure connector J615 is fully
seated and not routed under
the knob assembly.
29 Suds Lock
Abatement Failure
Cycle terminated due to excessive motor
current during spin.
 Ensure basket is able to rotate
freely.
 Check for anything that can
obstruct basket movement.
 Consumer education on correct
detergent (HE) and amount
usage.
30 Stuck Button A button is detected as being pressed for
more than 60 seconds.
 Ensure proper operation of all
buttons.
 Check for proper alinement
of the control board and
backsplash.
 Check the clearance between
the button and backsplash
hole.
(Continued next page)