GE Hydran 201i - Installing the CPU Module

Page 33
Hydran* 201
i
Installation Guide
17996 Rev5, August 2013
5.9 Installing the CPU Module
1. Align and carefully insert the CPU module on the central post of the Hydran
201Ti until the connector (at the back of the module) is completely inserted in
the mating connector.
2. Fasten the module with the two 6-32 screws (see Figure 18 below).
Figure 18: Installing the CPU Module
When fastening the CPU module, ensure not to bend the pins of
the connector located between the CPU and I/O modules.
CAUTION