GFK-2327B Chapter 3 Detailed Operation 3-29
3
When the switch is set to “ON”, the startup programs are forced to run and the
“Don’t run Startup Programs” button is not available on the startup splash
screen.
Note: Do not adjust switches other than switch 2. They are reserved for
factory functions.
To configure startup behavior
Caution
Disconnect power from your DC power supply before opening
the QuickPanel View. Working on a “live” unit may result in
damage to equipment and injury to personnel. Always use
anti-static precautions (i.e. grounded wrist strap) when
accessing the interior of the unit.
Caution
Do not allow conductive material, either liquid or solid, to
contact the electronics of the QuickPanel.
1. Open the back cover of the QuickPanel View.
2. Locate the DIP switches and set DIP switch 2 to “ON”. The startup
applications are now forced.
Note: Do not adjust the other switches. They are reserved for factory
functions.
To Next Page
Loading...
