Troubleshooting tips ... Before you call for service
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Surface units will not
maintain a rolling boil
or cooking is not fast
enough
Surface units do not
work properly
=
Possible Cause
Improper cookware being used.
In some areas, the power
(voltage) may be low.
A fuse in your home may be
blown or the circuit breaker
tripped.
Cooktop controls improperly set.
What To Do
Use pans which are flat and match the diameter of the
surface unit selected.
Cover pan with a lid until desired heat is obtained.
Replace the fuse or reset the circuit breaker.
Check to see the correct control is set for the surface unit
you are using.
m
Surface unit stops The unit is still on and hot. This is normal.
glowing when turned to
a lower setting
Scratches (may appear Incorrect cleaning methods Scratches are not removable. Tiny scratches will become
as cracks) on cooktop being used. less visible in time as a result of cleaning.
glass surface Cookware with rough bottoms To avoid scratches, use the recommended cleaning
being used or coarse particles procedures. Make sure bottoms of cookware are clean
(salt or sand) were between the before use, and use cookware with smooth bottoms.
cookware and the surface of the
cooktop. Cookware has been
slid across the cooktop surface.
Areas of discoloration Food spillovers not cleaned See the Cleaning the glass cooktop section.
on the cooktop , before next use.
Hot surface on a model with a This is normal. The surface may appear discolored when it is
light-colored cooktop, hot. This is temporary and will disappear as the glass cools.
Plastic melted to the Hot cooktop came into contact See the Glass surface--potential for permanent damage
surface with plastic placed on the hot section in the Cleaning the glass cooktop section.
cooktop.
Pitting (or indentation) Hot sugar mixture spilled on the Call a qualified technician for replacement.
of the cooktop cooktop.
Frequent cycling off arid Improper cookware being used. Use only flat cookware to minimize cycling.
on of surface units
My new oven doesn't Your new oven has a different For the first few uses, follow your recipe times and
cook like my old one. cooking system from your old temperatures carefully. If you still think your new oven
Is something wrong oven and therefore may cook is too hot or too cold, you can adjust the temperature
with the temperature differently than your old oven. yourself to meet your specific cooking preference.
settings? NOTE: This adjustment affects Bake, and Convection
Bake temperatures; it wilt not affect Convection Roast,
Broil or Clean.
Food does not bake , Oven controls improperly set.
properly
Rack position is incorrect or
rack is not level.
Incorrect cookware or cookware See the Cookware section.
of improper size being used.
Oven temperature needs See the Special Features section.
adjustment.
Ingredient substitution Substituting ingredients can change the recipe outcome.
-4
©
C
t"t3
I
©
©
--4
u
Z
©
--4
m
49806902 25
To Next Page
Loading...
Need help?
General
