GE JBP21 - Page 33

,.
..
STEPb
3 WIRE CONDUIT INSTALUTIOH
Removethe 3 screws from the connector
block.Insert bare wires between the connector
block terminals and movablenuts. Tighten
screws securely.Do not remove ground
strap connection.
I
c
B
s
BR
WARNING: CONNE~R BLOCK IS
APPROWD FOR COPPER ~RE
CONNE~ON ONLY. IF ALUMINUM
WRE IS USED, SEE NOTE BELOW.
NOTE: ALUMINUM WNNG
A. Do not connect Numinum wire to connector
block. Use copper buildingwire rated for the
correct amperage and voltageto make 3 (three)
3 inch copperjumper wires. Connect wire as per
Step 6 or 7 depending on number ofwires.
B. Splice copper wires to aluminum wiring using
special connector terminals designed and UL
approved for joining copper to aluminum and
follow the connector manufacturer’s
recommended procedure closely.
Wire used, location and enclosure of splices,
etc., must conform to good wiring practices and
local codes.
STEP7
4 WIRE CONDUIT INSTALUTION
Removethe 3 screws from the connector block.
Removethe grounding strap from the connector
block middle locationand the screw connecting
it to the frame ofthe range. Insert bare wires
between the connector block terminals and
movablenuts. Tighten screws securely.Attach
ground wire to the frame ofthe range.
BARE
WIRE TIPS
CONDUIT
WARNING:CONNECTORBLOCKIS
APPRO~D FORCOPPER~RE
CONNE~ON ONLY.IFALUMINUM
WRE IS USED,SEENOTEBELOW.
NOTE: ALUMINUM WMNG
A.
Do not connect Numinum wire to connector
block.Use copper building wire rated for the
correct amperage and voltageto make 3 (three)
3 inch copperjumper wires. Connectwire as per
Step 6 or 7 depending on number ofwires.
B. Splice copper wires to aluminum wiring using
special connector terminals designed and UL
approved for joining copper to aluminum and
follow the connector manufacturer’s
recommended procedure closely.
Wire used, location and enclosure of splices,
etc., must conform to good wiring practices and
local codes.
(continuednextpage)
33