STEP8
ANTI-TIP BRACKETIHSTWWTION
N
~TI-~P bracket is suppfiedwithinstructions
for installationin a varietyoflocations.The
instructionsincludea template,a parts fistand a
listoftoolsnecessary to completethe installation.
Readthe IMPORT~T S~~ INSTRU~ONS
and the instructionsthat fityour situationbefore
beginninginstallation.
WARNING
1. Rangemust be secured by NTI-~P bracket
suppfied.
2. See instructions to install (suppfiedwith
bracket).
3. Unless properly installed,range could be
tipped by stepping or sitting on door.Injury
might result from spilledhot tiquidsor from
range itseti.
TypicalInstallationofAnti-TipBracket
Attachmentto Wall
Bracket
ScrewMust Enter
STEP9
LEVELINGTHE RANGE
The
range must be level.bveling feet are located
at each corner ofthe base ofthe range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rohte the
levetingfeet in and out as required to levelthe
range. @or instructions on how to remove and
replace the storage drawer or the kick panel, see
the CleaningUnder the Rangesection in Care
and Cleaning.) On some models, there are plastic
covers which may be removed for easy
adjustment oust squeeze and pull).
One ofthe rear levefingfeet willengage the
~~-TIP bracket (allowfor some side to side
adjustment). Nlow a minimumclearance of 1/8
between the range and the levefingfootthat is to
be instilled into the NTI-TIP bracket.
Check the range for proper installationinto the
N~-TIP bracket (afterthe range has been
properly instilled) by removing the kick panel or
storage drawer and inspecting the rear leveling
leg. Make sure it fits securely into the slot.
STEP10
FINALCHECK
Be sure allswitches are in the OFF position
before leavingthe range.
34
To Next Page
Loading...
