Installation Instructions
E_] POWER CORD AND STRAIN RELIEF
[]
Remove the wire cover (on the lower back of
the range) bg removing two (2) screws using a
1/4" nut driver.
Do not discard these screws.
,=======/
2 screws to
remove wire
cover
Retaining
tab
[]
Back ofrange
Wire cover
Remove the knockout ring (l_/s") located on
bracket directlg below the terminal block. To
remove the knockout, use a pair of pliers to
bend the knockout ring awag from the
bracket and twist until ring is removed.
Terminal block
(appearance
mag varg)
Knockout ring
in bracket
Knockout ring
removed
[]
[]
3i
For power cord installations onlg (see the
next step if using conduit), assemble the
strain relief in the hole. Insert the power cord
through the strain relief and tighten. Allow
enough slack to easilg attach the cord
terminals to the terminal block. If tabs are
present at the end of the winged strain relief,
theg can be removed for better fit.
NOTE: Do not install the power cord without
a strain relief. The strain relief bracket
should be installed before reinstalling the
rear range wiring cover.
Terminal
Power cord Bracket
Skip to Step/4 or S.
For conduit installations onlg, purchase a
squeeze connector matching the diameter of
gour conduit and assemble it in the hole. Insert
the conduit through the squeeze connector and
tighten. Allow enough slack to easilg attach the
wires to the terminal block.
NOTE: Do not install the conduit without a
squeeze connector. The squeeze connector
should be installed before reinstalling the rear
range wiring cover.
Terminal
block
Squeeze
connector
Conduit
Skip to Step 6 or 7.
Bracket
To Next Page
Loading...
