Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting Tips Consumer Support
www.GEAppliances.ca
37
Problem Possible Causes What To Do
“F – and a number You have a function • Press the OFF pad. Put the oven back into
or letter” flash error code. operation.
in the display
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off from • See the Special features of your oven control section.
showing in the display.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BAKE and BROIL pads must be pressed
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the OFF pad, setting the clock and
resetting any cooking function.
“Burning” or “oily” This is normal in a new • To speed the process, set a self-clean cycle for a
odor emitting from oven and will disappear minimum of 3 hours. See the Using the self-cleaning
the vent in time. oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
No power supply from Small appliance plug is not • Make sure the small appliance plug is properly
convenience outlet completely inserted in the inserted.
on top of backguard convenience outlet.
(on some models)
The backguard is too hot • Allow the range to cool, then reset the circuit
and the convenience outlet breaker by pressing the switch located near the
breaker has tripped. convenience outlet.
Oven drawer or A fuse in your home may be • Replace the fuse or reset the circuit breaker.
warming drawer blown or the circuit breaker
will not work tripped.
Controls improperly set. • See the Electric warming drawer or Oven drawer section.
Excessive condensation Liquid in drawer. • Remove liquid.
in the drawer
Uncovered foods. • Cover food with lid or aluminum foil.
Temperature setting too high. • Reduce temperature setting.
Food dries out in Moisture escaping. • Cover food with lid or aluminum foil.
the oven drawer or
Drawer not fully closed. • Push drawer in until latch engages.
warming drawer
To Next Page
Loading...
Need help?
General
