Usingthe clock and timer, vvvvw.GEAppliances.com
Not all features are on all models.
Makesure theclockissetto the
correct timeof da_¢
To Set the Clock
Tile clock must be set to tile correct time
of (la_ fin" tile automatic oven timing
flmctions to work i)roperly. Tile time ot day
cmmot be changed dtwing a timed baking
or self=cleaning cycle.
[] Touch and hold tile TIMER/CLOCK pad
tmtil tile display changes.
[] Depending on which model )ou haxe,
you will set tile clock by touching
either tile + or - or tile number pads.
Touch tile number pads tile same wa))ou
read them. For example, to set 12:34, touch
tile number pads I,2, 3 and 4in that order:
If nmnber pads are not touched within one
minute after you touch tile TIMER/CLOCK
pad, tile display reverts to tile original
setting. /t this hal)pens, press and hold tile
TIMER/CLOCKpad and reenter tile time
of day:
[] Touch tile STARTpad until tile time
of day shows in tile display: This ente_
tile time and starts tile clock.
Tocheckthetl_neofdaywhenthedisplayis
showl))gotherinformation,s/_nplypressandhold
theTIMER/CLOCKpaduntilthetl_ne/sdisplayed
Thet/meof dayshowsuntilanotherpadis touched
@
OD@@D@D@3
@
Thetimeris a minutetimer onl_¢
TheCLEAB/OFFpad does not affect
flTetime_
To Set the Timer
Thet_Ynerdoes not control ovenoperations.
Themaximum setting on the timer is 9 hours
and 59 minutes.
[]
[]
Touch tile TIMER/CLOCK pad.
Touch tile + or - or tile number pads
tmtil tile mnolmt of time you want
sho_vs in tile display: The maim um
time that can be entered in minutes
is 59. Times more than 59 minutes
should be changed to hems and
minutes. For example, to enter 90
minutes as 1 hour 30 minutes, touch
I, 3 and 0 in that order:
If youmakeam/stake,touchthe TIMER/CLOCK
padandbeginagain.
[] Touch tile START pad. _dter touching
the STARTpad, SET disappeaxs; this
tells w,u tile time is COlmfing down,
although the display does not change
tmtil one minute has passed.
[] _._q/en tile timer reaches .'/70,tile
control will beep 3 times fi)llo_ed by
one beep every 6 seconds tmtil tile
TIMER/CLOCKpadis touched.
The6 secondtonecanbe canceledby following
thesteps in the Specialfeaturesof your ovencontrol
section under Tonesat the Endof a TimedCycle.
To Reset the Timer
If tile display is still showing tile time
remaining, you may change it by touching
tile TIMER/CLOCKpad, then touch tile + or
- or tile number pads tmdl tile time you
want appea_ in tile display.
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching tile TIMER/CLOCKpad and then
touching tile number pads to enter tile
new time VOtl w;Int.
To Cancel the Timer
Touch the TIMER/CLOCKpad twice.
Power Outage
If a flashing time is in the display,you have
experienceda power failure.Resetthe clock.
To reset tile clock, touch and hold tile
TIMER/CLOCK pad until the display changes.
Enter tile correct time of day l)y touching
tile ÷ or - or tile ai)propriate nmnber
pads. Touch tile START pad.
/5
To Next Page
Loading...
Need help?
General
