Careand cleaning of the range.
Oven Shelves
If your o',en is equipped with nickel oven
shelves, they should be remo\vd fl'om tile
oven befiwe beginning tile seltXclean cycle.
To clean tile nickel sheers, use all abrasive
cleanse*: Mter cleaning, rinse the sheers
with clean water and dIw with a clean cloth.
If the sheers e\vr become haM to slide,
wipe tile shelf edges or oven shelf supports
with vegetable oil.
If your o\vn is equipped with gray porcelain-
coated shelves, they mm be cleaned in tile
oven chMng tile selgclean cycle.
They may also be cleaned by using all
abrasive cleanse_: _Mter cleaning, rinse tile
shelves with clean water and chw with a
clean cloth. If tile shelves e',vr _)ecome hard
to slide, wipe the shelf edges or o\vn shelf
supports with vegetable oil.
ii; ¸::
i ii iii iiiiii
Wirecoverholder.
Oven Light Replacement
CAUTION: Beforerep/aclbgyour ovenhgbt bulb,
disconnectthee/ectncaipower to the rangeat the
male fuse orckcuit breakerpane/.Besure to iet the
iightcover and buib coo/compiete/y
Tile oxen light bulb is coxered with a
remox:O_le glass cover that is held in place
with a bail-shaped wire. Remove the oven
dora; if desired, to reach cover easily:
TO remove."
[_] Hold a hand under tile co;er so it
ii i
doesn't tifll when released. X,_ith
fingeI_ of tile salne hand, finnl} push
back tile wire coxer holdei: Lift off
the COX er,
Donot remove any screws to remove
the cover.
] Do not touch hot bulb with a wet
cloth. Replace bulb with a 40-watt
household appliance bulb.
Toreplace cover:
[] Place it into the groove of the light
receptacle. Pull the wire torward to the
center of tile cover until it snaps into
place. _]lell ill place, tile wire holds
tile cover fiI_nh'. Be certain tile wire
is in the depression in the center of
tile cover.
Connect electrical power to tile range.
[]
38
To Next Page
Loading...
