GE LOGIQ V5

GE LOGIQ V5/LOGIQ V3
D
IRECTION 5496012-100, REVISION 3BASIC SERVICE MANUAL
- 1 - 1
Chapter 1
Introduction
Section 1-1
Overview
1-1-1 Purpose of Chapter 1
This chapter describes important issues related to safely servicing the LOGIQ V5/LOGIQ V3. The
service provider must read and understand all the information presented in this manual before installing
or servicing a unit.
1-1-2 Purpose of Service Manual
This Service Manual provides installation and service information for the LOGIQ V5/LOGIQ V3 and
contains the following chapters:
1.) Chapter 1 - Introduction: Contains a content summary and warnings.
2.) Chapter 2 - Site Preparations: Contains pre-installation requirements for the LOGIQ V5/LOGIQ
V3.
3.) Chapter 3 - System Setup: Contains installation procedures.
4.) Chapter 4 - Functional Checks: Contains functional checks that are recommended as part of the
installation, or as required during servicing and periodic maintenance.
5.) Chapter 5 - Components and Functions (Theory): Contains block diagrams and functional
explanations of the electronics.
6.) Chapter 6 - Service Adjustments: Contains instructions on how to make available adjustments to
the LOGIQ V5/LOGIQ V3.
7.) Chapter 7 - Diagnostics/Troubleshooting: Provides procedures for running diagnostic or related
routines for the LOGIQ V5/LOGIQ V3.
8.) Chapter 8 - Replacement Procedures: Provides disassembly procedures and reassembly
procedures for all changeable Customer Replaceable Units (CRU).
9.) Chapter 9 - Renewal Parts: Contains a complete list of field replaceable parts for the LOGIQ V5/
LOGIQ V3.
10.)Chapter 10 - Care & Maintenance: Provides periodic maintenance procedures for the LOGIQ V5/
LOGIQ V3.
Table 1-1 Contents in Chapter 1
Section Description Page Number
1-1
Overview
1-1
1-2
Important Conventions
1-5
1-3
Safety Considerations
1-10
1-4
Lockout/Tagout (LOTO) requirements
1-14
1-5
EMC, EMI, and ESD
1-15
1-6
Customer Assistance
1-16