GE Mini Telemetry

22 2049809-001 Rev B © 2010 by General Electric Company. All rights reserved.
Chapter 4: Installation and Setup
Step Instructions
3. Connect the battery to the Battery Connector on the
circuit board. Perform step 2 and 1 in reverse order to
complete the battery installation.
Connecting Power Adaptor
Perform the following steps to connect the power adaptor.
Step Instructions
Instructions to connect the power adaptor:
1. Turn o the transmitter.
2. Locate the DC inlet jack and connect the DC
adaptor and plug the adaptor to AC mains
socket.
3. Switch on the AC mains with specied AC voltage
indicated in the specications. Charge the internal
battery for 4hrs before using the Transmitter.
Check for battery charge/full indication on the
display.
IMPORTANT : Power Adaptor —Use only the appropriate
country specic plug attachments to the Adaptor. The
Mini Telemetry system’s Adaptor comes with global
plugin options.