© 2010 by General Electric Company. All rights reserved. 2049809-001 Rev B 35
Chapter 6: Troubleshooting
This section of the manual provides a troubleshooting guide for the Mini Telemetry System’s operational
problems. If the response to a specic question is not found, contact service department. Refer to contact
details mentioned in the back cover.
Problem Chart
Troubleshooting
Problem Probable Cause Solution
Receiver Power indicator
does not light when the
receiver is turned on.
• Receiver not connected to AC
receptacle.
• Connect to AC receptacle.
• Defective AC power cord.
• Replace AC power cord.
• Use a dierent AC outlet.
Signal indicator
ashes with
transmitter turned
on.
• Transmitter antenna detached. • Contact your Service Representative.
(Reattach transmitter antenna as
instructed in Antenna Replacement
Chapter of Service Manual).
• Receiver antenna not attached. • Connect receiver antenna as instructed
in Chapter 4: Installation and Setup on
page 19.
• If problem persists, contact your
Information Technologies Service
Representative.
To Next Page
Loading...
Need help?
General
