4-4 F650 Digital Bay Controller GEK-113000T
4.4 LOGING INTO ENERVISTA 650 SETUP 4 SECURITY
4
4.4LOGING INTO ENERVISTA 650 SETUP
Users have to log on in order to use EnerVista 650 Setup program after Security Control has been enabled. After the start
up of EnerVista 650 Setup, a dialog will pop up asking for user name and password.
Figure 4–3: LOGIN USER
The user name field will display the last log in user name as default, in this example, TestUser. For the first log in session of
any user name, the default password will be "password". User will be prompt to change the password to something else
after the first successfully log in.
Log on can also be done by clicking Security from the toolbar and choose Login New User. User will be prompted with the
same log in dialog box for a different user name and password combination.
In case a user has forgotten about the log in password, the Forgot Password function can be used to retrieve the
password.
Figure 4–4: FORGOT YOUR PASSWORD?
A question, which is pre-set by the user, will be asked. The password will be retrieved for entering the right answer.
To Next Page
Loading...
Need help?
General
