GE Multilin F650 - Page 187

A-8 F650 Digital Bay Controller GEK-113000T
A.1 LOGIC OPERANDS APPENDIX A
A
OPERANDS - F650 - MODEL FX - GX
INTERNAL SYSTEM STATUS (CONT.)
I Key I key operation (Programmable signal via PLC)
O Key O key operation (Programmable signal via PLC)
Programmable Keypad Status (HMI) * Key * key operation (Programmable signal via PLC)
F1 Key F1 key operation (Programmable signal via PLC)
F2 Key F2 key operation (Programmable signal via PLC)
LOCAL/REMOTE Operation status LEDs
LOCAL OPERATION
MODE
Local/remote status for operations 1 = Local, 0 =
Remote. Selectable through the front pushbutton
(Hardware) and also through communications
(software).
OPERATIONS
BLOCKED
Operations OFF status (1) Command execution block
(operations blocked both in local and remote
mode)
.Selectable through the front pushbutton
(Hardware) and also through communications
(software).
LOCAL/REMOTE/OFF Selection
CHANGE LOCAL-
REMOTE
Changing local-remote status by communications
CHANGE OP BLOCKED Operations Block-Unblock signal
HMI Tab Order Selection (Swithgear selection
status in HMI)
HMI Tab Order 01 HMI element 1 selection. 0 = Not selected, 1 =Selected.
The selection is performed through the SEL front key.
When the element 1 has it selection enabled, it can be
commanded through the O and I front keys.
HMI Tab Order 02 HMI element 2 selection. 0 = Not selected, 1 =Selected.
The selection is performed through the SEL front key.
When the element 2 has it selection enabled, it can be
commanded through the O and I front keys.
... ...
HMI Tab Order 16 HMI element 16 selection. 0 = Not selected, 1
=Selected. The selection is performed through the SEL
front key. When the element 16 has it selection enabled,
it can be commanded through the O and I front keys.
HMI Backlight
HMI BACKLIGHT ON
"Switching on backlignt" signal (the display is switched
on by communications
HMI BACKLIGHT OFF
"Switching off backlignt" signal (the display is switched
off by communications