15
B.
SETTING THE KEYPAD TONE
1.
Press
À
W
.
Keypad is now in the “Adjust Tone” mode.
2.
Press
x
located on the right side of
the display to adjust the keypad
sounder to higher tones.
3.
Press
y
to adjust the keypad sounder
to lower tones.
4.
When the desired tone is reached, press
to set this tone and exit.
C.
VIEW ALARM MEMORY
1.
Press
À
Z
to display the zone(s) on the keypad that created the last alarm.
2.
The LCD screen will display the zone
description for those zones.
3.
Press
to exit.
D.
TEST FUNCTION
(Optional if programmed)
This function will perform a battery test, communicator test, and/or a siren test. No
alarms will be sent, and no reports will be sent unless a communicator test is performed,
in which case a test signal will be sent.
1.
Press
À
[
[
. The test will be performed as programmed.
2.
If the siren test is performed, enter a user code to silence the siren.
5DLVHWRQH
/RZHUWRQH
$
O
DUP0HPRU\
=21(
To Next Page
Loading...
Need help?
General