XXV. APPENDIX A - EVENT LOG
NOTE: Your system may not have all of the features listed in this table.
DISPLAY DESCRIPTION
TXlobat
Transmitter Low
Battery
The transmitter has a low battery.
ZN Lost
Zone Lost
A wireless or multiplexed zone device is not
reporting to the control.
Duress
Duress
The control has been armed or disarmed with a
Duress code.
Man Fire
Manual Fire Keypad “Fire” has been activated.
Aux 2
Auxiliary 2 Keypad “Medical” has been activated.
Panic
Panic Keypad “Panic” has been activated.
KP Tamper
Keypad Tamper The keypad tamper has been activated.
BoxTamp
Box Tamper The box tamper circuit has been activated.
AC Fail
AC Fail AC failure has been detected.
OverCur
Over Current A short circuit of a power supply has occurred.
Srn Tamp
Siren Tamper A siren or speaker tamper has been detected.
Tel Flt
Telephone Fault A telephone fault or tamper has been detected.
Exp Trb
Expansion
Trouble
An expansion device or keypad is not reporting to
the control.
Log Full
Log Full
The event log is full. Old events will be pushed
out as new ones enter the log.
Open
Open Reports user number, date, time and partition of
opening.
Close
Close Reports user number, date, time and partition of
closing.
Exit Err
Exit Error
Entry/Exit zone was faulted at the instant the exit
delay expired.
Rec Close
Recent Close
An alarm occurred within 5 minutes after the
control was armed.
Autotest
Auto Test
Sending a communicator test at a specified
interval.
To Next Page
Loading...
Need help?
General