GE NetworX NX-1192E User Manual

29
DISPLAY DESCRIPTION
Start Prog
Start
Programming
Local programming is started.
End Prog
End
Programming
Local programming is ended.
Start Dnld
Start Download Download session is started.
End Dnld
End Download Download session is ended.
Cancel
Cancel
System is disarmed and the Cancel button was
pressed within 5 minutes of an alarm.
Gnd Flt
Ground Fault A short to ground has been detected.
Man Test
Manual Test Bell and/or communicator test while system is in
disarmed condition.
Re-exit
Re-Exit
The exit delay has been re-started without
disarming the system.
Output Trip
Output Trip
A trip has occurred on an expander auxiliary
output.
Data Lost
Data Lost
Communication of a signal has failed (log only
event).
Walk-test
Walk-Test A zone “Walk-Test” mode has been activated.
End Test
End Test Test has been ended.
Cross-Trip
Cross Trip
The first zone of a cross zone has been tripped
(log only).
Expansion
Event
Expansion Event
An expansion module created an undefined
event.
Partial Arm
Partial Arm Reports a closing in the stay mode.
Listen In
Listen In A listen in function has been activated.
Service Start
Service Start Technician is on site.
Service End
Service End Technician is off site.
Code Entry
Code Entry A code has been entered.
First Open
First Open Reports when the first partition is disarmed.
Last Close
Last Close Reports when the last partition is armed.
Sprnklr
Sprinkler Instant sprinkler supervisory report
Clock Set
Clock Set Clock has been reset.

GE NetworX NX-1192E Specifications

General

Brand	GE
Model	NetworX NX-1192E
Category	Keypad
Language	English