GE Profile PGCS1RKZ

– 24 –
4. Using a fl at blade screwdriver, push down and
remove the metallic water line support from
each water line.
Cover
(Continued next page)
Metallic Support
Fresh Food Door Removal
To remove the fresh food door:
1. Open the top freezer drawer.
Note:
• The following procedure applies to removing the
left-side door with dispenser. Follow this same
procedure for removing the right-side door.
There are no wires, water lines, or center hinge
covers on the right-side door.
• If removing the left-side door, it may be helpful
to reduce weight by removing the ice bucket
from the door.
2. Remove the screw securing the center hinge
cover.
3. Pull the right side of the hinge cover out and
remove the cover from the hinge.
7. Carefully push the collar in while pulling each
water line out from the coupling.
*Replacement collar unavailable
5. Using a fl at blade screwdriver, push the red
plastic lock clip off each water line collar.
6. Disconnect the door wire harness.
Note: The red plastic clip and the water line for the
icemaker is smaller than the clip and the water line
for the dispenser.
Red Plastic Lock Clip
Disconnect
Water Line
*Collar
Icemaker
Water Line
Dispenser
Water Line