– 38 –
Fresh Food and Freezer Lights
Fresh Food LED Lights
Note: Setting the controls to OFF does not remove
power to the LED light circuit.
The fresh food section utilizes 9 LED light assemblies
and the freezer utilizes 1 LED light assembly. All 9
fresh food LEDs are wired in parallel.
When a door or drawer is left open continuously
for 10 minutes, the main control will turn off the
lights. Once the door or drawer is closed and then
opened, the 10-minute count starts over.
13.6 V RED
MAIN CONTROL BOARD
J2-8
J5-3
PINK
J14 -4
BLACK
PINK
RED
FF LED ASM
(ALL 9 FF LED
ARE CONNECTED
IN PARALLEL)
BLACK
Fresh Food LED Schematic
J14-4 = LED Ground
J2-8 = 13 VDC
J5-3 = LED Enable
Double Coil Water Tank
The double coil water tank is located in the bottom
of the fresh food compartment. (See Components
Locator Views.) The icemaker and dispenser water
tank supply tubes, connected to the water valve,
enter the fresh food compartment near the right
side tank. Both tubes connect to exit tubing using
John Guest couplings. Exit tubing located inside the
liner connects to the disconnect collars located near
the left-door bottom hinge and cannot be replaced.
To remove the water tank:
1. Remove the fruit and vegetable crisper drawers
and the crisper drawer cover and frame
assembly.
2. Using a fl at blade screwdriver, push the top
black plastic lock clip (if utilized) off each
coupling.
3. Carefully push the collar in while pulling each
water line out from the coupling.
4. Remove the two 1/4-in. hex-head screws that
attach each water coil.
Note: In the following step, water may drain from
disconnected tubing. Use care to avoid water spills.
5. Disconnect icemaker and water tank tubing
from the water valve. (See
Water Valve.)
6. Carefully pull water tank and tubing from the
fresh food compartment.
Collar
Collar
Clip
Clip
(Continued next page)
To Next Page
Loading...
