EasyManua.ls Logo

GE Profile PGCS1RKZ

GE Profile PGCS1RKZ
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 27 –
Drawer Removal
To remove the drawer:
1. Remove the freezer basket. (See Freezer Basket,
this section.)
2. Loosen (do not remove) the T-30 Torx screw at
the top of the left side slide assembly.
3. Remove the two T-30 Torx screws from the
bottom of each slide assembly.
(Continued next page)
4. Tilt the drawer panel 45 degrees out from the
bottom, and then lift up and remove the drawer
from the slide assemblies.
5. Push the slide assemblies back into the cabinet.
Remove
Left Side Bracket Shown
Loosen
Divider
Swing Lock (1 of 4)
Bottom Freezer Drawer
Freezer Basket
1. Open the bottom freezer drawer until it stops.
2. Pull the divider forward until the rear locating
tabs are out of the slots. Turn the divider slightly
to the side to release the front locating tabs and
lift out.
Note: The freezer basket front section rests on the
metal slide brackets and is held in place with swing
locks.
3. Turn the swing locks from vertical to horizontal
position. Open fresh food doors.
4. Lift the basket front section up and rotate
it toward you. Slide out from the side of the
drawer.
5. Lift the basket rear section from the metal slide
brackets.
Basket Front Section
Basket Rear Section

Related product manuals