49-3000244 Rev 7 13
CARE AND CLEANING
Care and Cleaning
Fabric Refresh Tank
Clean the tank when switching to a different approved liquid or as needed. The tank is located on the inside of the
dryer door.
To clean the tank:
1
Press the button to release the Fabric Refresh door,
and then pull it down to open.
2
Remove the tank by grasping its handle and pulling it
out.
3
Release the tank cap by turning it counter-clockwise
and lift it up to remove.
4
Run hot water into the tank. Replace the tank cap
and turn it clockwise making sure the indents align.
Shake the tank gently.
5
Drain the water over a sink by pressing the drain
button located at the bottom of the tank.
Repeat fill, shake and drain until the water is clear.
6
Replace the tank by aligning it properly to its
compartment and sliding it back into place.
Make sure to push it all the way in.
7
Close the Fabric Refresh door.
CAUTION
Water might be hot. Wear heavy rubber dish
washing gloves to press the drain button to avoid
the draining hot water.
Fill with hot water and replace cap
Shake gently to clean
Press to drain water
To Next Page
Loading...
Need help?
General
