– 18 –
8. Carefully pull out the 5 plastic tabs that attach
the power and display/logic boards together.
6. Disconnect the wiring from the power board .
7. Remove the 10 Phillips-head screws that attach
the control board assembly to the control panel.
Remove the assembly.
9. Disconnect the 2 electrical connectors from the
power board.
Tab (1 of 5)
Water Valve
The water valve consists of a valve body and 5
solenoid coils. It is only available as a complete
assembly.
Each solenoid controls a specifi c water function.
When energized, there should be approximately
5-6 VDC
at the appropriate coil.
Each coil on the water valve assembly has an
approximate resistance value of 30 Ω.
Pink colored plastic pressure fi ttings are used on
the water valve for a tight fi t and to reduce the
possibility of leaks.
Note: Hot and cold water inlet screens are used to
prevent debris from entering the valve assembly.
Inlet screens can be removed by grasping hold of
the handle on the rear of the screen with a pair of
needle nose pliers and pulling it straight out. After
cleaning, insert for continued use.
To remove the water valve assembly:
1. Turn off the hot and cold water supply valves,
and then remove the fi ll hoses from the back of
the washer.
2. Place the control panel in the service position.
(See
Control Panel.)
(Continued Next Page)
Note: The control panel, selector buttons, and pads
are replaced as a complete assembly.
Disconnect
To Next Page
Loading...
