Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsCare and Cleaning
6
Care and cleaning of the vent hood.
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part
of the vent hood.
Do not use a steel wool pad;
it will scratch the surface.
To clean the stainless steel
surface, use warm sudsy water
or a stainless steel cleaner or polish.
Always wipe the surface in the
direction of the grain. Follow the
cleaner instructions for cleaning
the stainless steel surface.
To inquire about purchasing
stainless steel appliance cleaner
or polish, or to find the location
of a dealer nearest you, please call
our toll-free number:
National Parts Center
800.626.2002
ge.com
Stainless Steel Surfaces
Light Bulbs
CAUTION:
Allow bulbs to cool before touching.
To change the light bulbs:
1. Remove the lamp lens cover by
inserting a small flat blade screwdriver
into each of the three slots and gently
prying it free.
NOTE: Do not remove the outer trim ring
(lamp assembly).
2. Wear gloves. Do not touch the bulb
with your bare fingers. Skin oils can
cause early lamp failure.
3. Grasp the bulb and pull it straight out.
4. Replace with the same wattage. Early
bulb failure and damage to or failure of
the transformer may occur if wattage
is too high.
These 12-volt, 20-watt halogen bulbs
with a G4 base are available at
specialty lighting stores and home
building centers.
To order replacement bulb no.
WB01X10239, contact the GE National
Parts Center at 1.800.626.2002 or
purchase from your local retailer.
5. Replace lamp lens cover by inserting
the three retaining tabs into the three
slots and pressing firmly in place.
Use a small flat blade screwdriver
to remove the lamp lens cover.
Outer trim ring
(lamp assembly)
Do not remove
Bulb
Removable inner
lamp lens cover
NOTE: Make sure the tabs are inserted into the slots.
Tab
To Next Page
Loading...
Need help?
General
Weight and Dimensions
