GE PVM9179 Series User Manual

Place the blower unit back into the opening.
WARNING:5LVNRIHOHFWULFVKRFN
can cause injury or death. Do not pull or stretch
WKHEORZHUXQLWZLULQJ0DNHVXUHWKHZLUHGDUH
not pinched.
7
6
5
ADAPTING BLOWER FOR
RECIRCULATION
(continued)
C3
21
Replace blower plate with the screws removed in
Step 1.
Secure blower unit to oven with the 2 screws
removed in Step 2. Insert the screw in bottom right
screw hole on the back of the oven.
Blower Motor
Screw
Installation Instructions
C4
Blower Plate Screws
Back of Oven
CAUTION: 7RDYRLGWKHULVNRISHUVRQDO
LQMXU\EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH
ZHLJKWRIWKHPLFURZDYHRYHQRUSURSHUW\GDPDJH
\RXZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH
RYHQ
IMPORTANT: Do not grip or use handle during
installation.
WARNING: 5LVNRI(OHFWULF6KRFN&DQ
cause injury or death: If installing unit with metal
FRXQWHUWRSVFRYHUWKHHGJHRIWKHSRZHUVXSSO\
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
T
u
r
n
t
o
S
e
l
e
c
t
P
r
e
s
s
t
o
E
n
t
e
r
NOTE: When mounting
the microwave oven,
thread power cord through
hole in bottom of top
cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
by pulling cord.
Lift microwave oven,
tilt it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting plate.
1
2
Rotate front of oven up
against cabinet bottom.
MOUNT THE OVEN

GE PVM9179 Series Specifications

General

Brand	GE
Model	PVM9179 Series
Category	Oven
Language	English