7
TO INSTALL THERMOSTAT (cont.)
10. Seal hole for wires behind thermostat with non-
flammable insulation or putty, or use a wall plate
obtainable from a local hardware or home building
store.
11. Use supplied screws to mount thermostat base to
wall.
12. Insert stripped, labeled wires in matching wire
terminals by pressing on the corresponding terminal
contact. See the “Wiring Diagrams” section of this
manual.
NOTICE
Make sure exposed portion of wires does not touch
other wires.
13. Gently tug wire to be sure of proper connection.
Double check that each wire is connected to the
proper terminal.
14. Replace cover on thermostat by snapping it in
place.
15. Plug the unit in or turn on power to the system at
the main service panel.
16. Test thermostat operation as described in the
“Testing the Thermostat” section.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
