;
,(
3–1 Lefthand Section of Control Keyboard
See Illustration 1–9
The lefthand section of the Control Console Keyboard is used to initialize or select
generator parameters.
" ! <=
.! ( .! ' ' (, !
"#
" ! <=
.! (
!5
/ ;, + 1 *&. 3/ +
!! ", ! "# ($
D Language of messages
D Speed of compression
D Programming maximum compression force
D Automatic decompression.
D Warning beep (maximum compression force reached)
D Height of automatic decompression.
D Disabling of exposure interlock
Note: Access and description of all these parameters is given in Chapter 3, Maintenance.
:5
.! ( )8!
D The upper line displays warning messages and fault messages.
D The lower line displays selected parameters: focal spot, focal track, filter, FDC,
and SFC.
Note: In SET UP mode, the operator can move within the menus and modify technical
parameters (refer to Chapter 3, Maintenance).
Note: FDC = Film Density Control
SFC = Screen-Film Combination
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
