EasyManua.ls Logo

GE SmartWater GXRM10 User Manual

GE SmartWater GXRM10
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTALLATION INSTRUCTIONS
For use with models GXRV10, GXRM10, PNRQ15, PNRQ20,
PNRV12 (beginning on page 1) and PNRV18 (beginning on page 4)
INSTALLATION NOTES
Use pipe thread_ealing rope (provided) on threaded
COIlnefiliOIlS.
Tubing may be cot 1o desired length.
When connecting Ihe kit to a refligerator water dispenser,
a slightly lower dispenser water pressure may be noticed.
This is llormal.
It is normal for tile GREEN light to flash on tile faucet monitor
when tile icemaker or dispenser calls for water (on some
models).
Before installing the icemaker ki_ install the Reverse Osmosis
Filtration System according to the installation instructions,
KIT CONTENTS
Storage tank
Tank adapter
6 ft. 3/8" orange robing
2 "lee fit/ings with
push-to-connect ends
Brass tubing adapter, nut and
washer asseInhly
33 IL 3/8" blue robing
Pipe lhread tape
1 ft. 3/8" orange robing
TOOLS AND MATERIALS REQUIRED
Ufilily knife
Pliers and adjuslablejaw wrench
CONNECTING THE AUXILIARY TANK FOR MODELS GXRV10, GXRM10, PNRQ15, PNRQ20, PNRV12
I, Turn off file iceInaker.
2 Turn off the water supply m tile Reverse Osmosis Fihra/ion
System by closing the water supply valve (Fig. 1).
3, Dr'ain the RO system and tank. Ttlrn Oil file RO faucet located
on Ihe sink or counterlop (Fig. 1). Let tile water drain fkom tile
s_teIn until water has stopped flowing. On models equipped
wifll a tank shomffvalve, make sure tile valve is open _) that tile
tank will drain. (lose tile RO fauceL
5.
Cut the 3/8" tubing that coIlnefils the storage tank to Ihe RO
s_teIn (Fig. 2); this robing will be either orange, gray or while,
depending on model Make sure the cot is clean and straight
widl IlO burrs or crimps. Insert on "lee titling between tile two
cut ends of tile robing (Fig. 2). Push Ihe tobing into lhe fitting
until it slops--about 1/2". Give robing a lug m Inake sure it is
seated securely.
ConIlect tile tank to file Tee osiIlg file 6 ft. lengfll orange
robing.
Fig. 1 _)_ _ RO watt'r faucet
(lift lever to open)
H H
H H
H H
H H
!! ,,
*_lveWatersuppl_To drain
Fig. 2
Smrage tmik
Reverse Osmosis
_in
Iut
Tce fitdng
Auxilim T
storagetm_k
(induded
with R'_NIT)
215C1044P031 (II-04JR) 49-50138
www.GEAppliances.com
GENEtb\L ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
Question and Answer IconNeed help?

Do you have a question about the GE SmartWater GXRM10 and is the answer not in the manual?

GE SmartWater GXRM10 Specifications

General IconGeneral
Product TypeReverse Osmosis Filtration System
Filtration MethodReverse Osmosis
Stages of Filtration3
Installation TypeUnder Sink
CertificationsNSF/ANSI 58
Filter Life (Months)6-12 months
Filter TypeSediment, Carbon
Daily Production Capacity10 gallons per day

Summary

GE SmartWater RVKIT Installation Guide

Installation Notes, Kit Contents, and Tools

Provides essential installation notes, lists kit components, and required tools for setup.

Connecting Auxiliary Tank (Models GXRV10, GXRM10, PNRQ15, PNRQ20, PNRV12)

Steps for connecting the auxiliary storage tank to the RO system for specific models.

Connecting to Icemaker (Models GXRV10, GXRM10, PNRV12)

Instructions for connecting the filtered water line to the icemaker for these models.

Sanitizing System (Models GXRV10, GXRM10, PNRV12)

Procedures for sanitizing the water filtration system after installation.

Sanitizing System (Models PNRQ15, PNRQ20)

Sanitization steps specific to PNRQ15 and PNRQ20 models.

Connecting Auxiliary Tank (Model PNRV18)

Steps for connecting the auxiliary storage tank for the PNRV18 model.

Connecting to Icemaker (Model PNRV18)

Instructions to connect the filtered water line to the icemaker for the PNRV18 model.

Sanitizing System (Model PNRV18)

Steps for sanitizing the Reverse Osmosis system for the PNRV18 model.

Related product manuals