To Next Page

To Previous Page

Chapter 7 – Configuration

GE Reason Switches

REASON SWITCHES-TM-EN-3

155

After one of the configurations described before is changed, there are two buttons

that allow the user to save or discard the configurations.

o Save: save configuration at the Running Config;

o Reset: undo changes made locally at the Running Config.

 Access:

Groups menu allows configuring SNMPv3 access table. By default, default_ro_group

and default_rw_group are created. To add new access configuration, click at the Add

New Entry button and the following field will appear:

o Delete: click at the button to delete the filter at the row;

o Group name: select group name to be configured. Group names

listed are get from the Groups menu;

o Security Model: select security model to be used in the access.

Allowed values are any, v1, v2c and usm. Choose any if any

security model may be used. USM security model is the user-based

security model. V1 and v2c security models are reserved for

SNMPv1 and SNMPv2c use;

o Security Level: select the security model to be used for the

selected group. Possible values are NoAuth, NoPriv, Auth, NoPriv

and Auth, Priv. “No” at the beginning means no use of authorization

or privacy. Thus, it is possible to choose from no authentication and

no privacy, authentication and no privacy and, finally,

authentication and privacy security levels;

o Read View Name: select the name which will be shown of this MIB

when requested current values. Possible values are None,

default_view or the name of a given view. None means no view

name, default_view means that MIB will be displayed as

default_view and, if a view is created, its name typed at the Views

menu can be used as MIB’s name;

o Write View Name: select the name which will be shown of this MIB

when potentially set new values. Possible values are None,