GE T1000 User Manual

GE Reason Switches
Chapter 7 – Configuration
178
REASON SWITCHES-TM-EN-3
After one of the configurations described before is changed, there are buttons that
allow the user to save or discard the configurations.
 Save: save configuration at the Running Config;
 Reset: undo changes made locally at the Running Config.
o Port Filtering Profile:
This menu allows configuring filtering condition to be applied at the ports based on
the IPMC profile. IPMC profiles used are the profiles added at the IPMC Profile menu.
 Port: shows the ports to be configured at this row;
 Filtering Profile: indicates which profile can be selected to
be used by this port. Allowed values are the profile names
configured at the Profile Table at the IPMC Profile menu.
The “-“ field means no filtering profile being applied to this
port.
After one of the configurations described before is changed, there are buttons that
allow the user to save or discard the configurations.
 Save: save configuration at the Running Config;
 Reset: undo changes made locally at the Running Config.
 MLD Snooping:
MLD Snooping menu contains basic configuration of the IPMC function. MLD will be
the mechanism to allow multicast communication in an IPv6 environment.
o Basic Configuration
 MLD Snooping Configuration: indicates basic MLD
snooping configuration. Possible configuration is as
follows:
 Snooping Enabled: enable MLD Snooping
function at the switch. Checkbox selected means
function enabled, and checkbox empty means
disabled;
 Unregistered IPMCv6 Flooding Enabled: enable
unregistered IPMCv6 traffic flooding at the
switch. This function only takes effect if MLD
Snooping is enabled. Unregistered traffic
flooding is the unknown multicast traffic, and if
enabled, this function will forward these packets

GE T1000 Specifications

General

Brand	GE
Model	T1000
Category	Switch
Language	English