GE T1000 User Manual

GE Reason Switches
Chapter 7 – Configuration
208
REASON SWITCHES-TM-EN-3
ports will be used at this
QCE. Values must be
inserted in decimal
format.
 Dport: indicates which
destination TCP ports will be
used at this QCE. Possible
configuration is as follows:
 Any: indicates that all
incoming frames will be used
at this QCE;
 Specific: indicates that only
specified TCP port will be used
at this QCE. Values must be
inserted in decimal format;
 Range: indicates that only a
range of specified TCP ports
will be used at this QCE. Values
must be inserted in decimal
format.
o Other: indicates which IP protocol
number will be used at this QCE, that is,
this entry will map frames based in
many parameters including if it is
specified IP protocol. Values must be
inserted in decimal format.
 SIP: indicates which filter should be applied based on the
IPv4 source address at the frame. Possible configuration
is as follows:
 Any: indicates that all source IP address frames
will be used at this QCE;
 Specific: indicates that only specified IP address
will be used at this QCE. Values of the IP address
and mask allowed are dotted decimal notation;
 IP Fragment: indicates if IPv4 fragmented frames will be
allowed in this QCE. Allowed values are Yes or No, where
yes means accepts fragmented frames for this entry and
no means no fragmented frames would be accepted in
this frame;
 DSCP: indicates which DSCP values will be allowed in this
QCE. Possible values are Any, Specific and Range. Possible
configuration is as follows:
 Any: indicates that all incoming frames will be
used at this QCE;

GE T1000 Specifications

General

Brand	GE
Model	T1000
Category	Switch
Language	English