2.3 Emergency procedures
Introduction
This section describes how to perform an emergency shutdown of Monitor UVis-920.
The section also describes the result in the event of power failure.
Emergency shutdown
In an emergency situation, do as follows to stop the run:
Switch off power to the instrument by switching the On/off switch on the rear panel to
the (O) position. If required, disconnect the mains power cord. The run is interrupted
immediately.
Power failure
In the event of power failure the run is interrupted immediately.
2.4 Recycling information
Decontamination
Monitor UVis-920 shall be decontaminated before decommissioning and all local regu-
lations shall be followed with regard to scrapping of the equipment.
Disposal, general instructions
When taking Monitor UVis-920 out of service, the different materials must be separated
and recycled according to national and local environmental regulations.
Recycling of hazardous
substances
Monitor UVis-920 contains hazardous substances. Detailed information is available from
your GE representative.
Monitor UVis-920 Operating Instructions 29055049 AD 17
2 Safety instructions
2.3 Emergency procedures
To Next Page
Loading...
