Operating Instructions
16 VeriDri™ User’s Manual
7.4 Moisture Sensor Specifications
Sensor Type
Thin-film aluminum oxide moisture sensor probe
Calibration
Each sensor is individually computer-calibrated against known moisture
concentrations, traceable to NIST
Calibration Interval
Factory sensor recalibration by GE Sensing is recommended every
6-12 months, depending on the application
Calibration Data
Factory-calibrated, stored in
FLASH memory
Flow Rate
• Gases: Static to 10,000 cm/s linear velocity, at a pressure of 1 atm
• Liquids: Static to 10 cm/s linear velocity, at a density of 1 g/cc
To Next Page
Loading...
