2-22 VersaMax Modules, Power Supplies and CarriersUser Manual GFK-1504N
2
Wiring for a Box-Style I/O Carrier or Spring-Style I/O Carrier
(IC200CHS002, IC200CHS005)
Each terminal on a Box-Style or Spring-Style I/O Carrier accommodates one
solid or stranded AWG #14 (avg. 2.1mm
2
cross section) to AWG #22 (avg.
0.36mm
2
cross section) wire, or two wires up to AWG #18 (avg. 0.86mm
2
cross
section). Use copper wire rated for 90 degrees C. When inserting two wires in
the same position, the wires must be the same size and type (solid or stranded).
The I/O carrier can accommodate current levels up to 2 Amps per point or 8
Amps per each power and ground, and a voltage range of up to 264 V AC.
Voltage transients up to 300 V AC will not damage the carrier.
For a Box-Style I/O Carrier, recommended terminal torque is 0.37 to 0.45 ft-lbs.
The label provided with the module can be folded and inserted in the module’s
transparent door.
Terminal Numbering for a Box-Style or Spring-Style I/O Carrier
To Next Page
Loading...
