GE WCVH6800J1WW - Unpacking and Shipping Hardware Removal

Installation Instructions
UNPACKING THE WASHER
-A WARNING: Recycleor destroy the carton
and plastic bags after the washer is unpacked. Make
materials inaccessibleto children.Children might use
them for play. Cartons coveredwith rugs,bedspreads
or plastic sheets can become airtight chambers causing
suffocation.
1. Cut and remove the top and bottom packaging straps.
2. Whileit is in the carton, carefully lay the washer on its
side.DO NOTlag the washer on its front or back.
3. Turn down the bottom flaps-remove all base packaging,
including the cardboard, styrofoam base and styrofoam
tub support (insertedin center of base).
NOTE: If you are installing a pedestal, proceed to
the installation instructions that come with the pedestal.
4. Carefullyreturn the washer to an upright position and
remove the carton.
5. Carefullymove the washer to within 4 feet (122 cm)
of the final location.
6. Removethe following from the back side of the washer:
4 bolts
4 plastic spacers (including rubber grommets)
4 power cord retainers
NOTE:Failureto remove the shipping braces can cause
the washer to become severely unbalanced.
Saveall bolts for future use.
NOTE:If you must transport the washer at a later date,
you must reinstall the shipping support hardware to prevent
shipping damage. Keepthe hardware in the plastic bag
provided.
Incase you misplace your shipping bolt, replacements
are available at additional cost. They can be ordered in
the United States by visiting our website at ge.com or
calling 800.GE.CARES.Order kit #WH49×10039.
16