Installation Instructions
INSTALLING THE WASHER Icont.I
7. Attach U-shaped hose guide to the end of the drain
hose. Place the hose in a laundry tub or standpipe
and secure it with the cable tie provided in the
enclosure package.
NOTE:If the drain hose is placed in a standpipe without
forming a U shape, a siphoning action could occur There
must be an air gap around the drain hose.A snug hose
fit can also cause a siphoning action.
CableTie7 Cable Tie 7
I
Cable Tie
8.
Plug the power cord into a grounded outlet.
NOTE:Check to be sure the power is off at a circuit
breaker/fuse box before plugging the power cord into
an outlet.
9. Turn on the power at a circuit breaker/fuse box.
10. Read the rest of this Owner's Manual. It contains
valuable and helpful information that will save you
time and moneg.
11. Before starting the washer, check to make sure:
CI Main power is turned on.
CIThe washer is plugged in.
CIThe water faucets are turned on.
CIThe unit isleveland all four leveling legs are firmly
on the floor
CIThe shipping support hardware is removed
and saved.
CIThe drain hose isproperly tied up.
E]Thereare no leaks at the faucet, drain line
or washer
12. Run the washer through a complete cgcle.
Check for water leaks and proper operation.
13. If your washer does not operate, please review
the Before YouCall For Servicesection before
calling for service.
14. Place these instructions in a location near the washer
for future reference.
REPLACEMENT PARTS
If replacement parts are needed for your washer,they
can be ordered in the United States by visiting our
Website at ge.com or by calling 800.GE.CARES.
19
To Next Page
Loading...
