– 36 –
Note: Press CUSTOM 2 to index to next function. Press CUSTOM 1 to index to previous function.
Note: A detailed definition of each service mode function can be found on the following pages.
To enter service mode:
1. Turn power off.
2. Remove power from unit.
3. Restore power to unit and within 30
seconds of power-up, simultaneously
press and hold POWER and START
buttons for 3 seconds.
Fast Spin Test
Activates 850 rpm spin.
Press START to display
rpm.
Press
CUSTOM 2
High Pressure Switch Test
Displays state of
high level switch.
HOP = open, HCL = closed.
Pressing START will fill washer
to Giant level.
User Interface Test.
All LED's and LCD's
illuminated. Press START to
toggle checkerboard on LCD.
Error Codes
Displays most recent error code.
Press START to clear error and
view next most recent error.
Low Pressure Switch Test
Displays state of low
level switch,
LOP = open, LCL = closed.
Pressing START will fill
washer to Extra Small level.
EEPROM Test
Displays EEP.
Press START pad to reprogram
EEPROM. Successful reprogramming
is confirmed by beep.
Software Version
Displays software version #.
Press START to displays EEPROM #.
Model Display
Displays Model version #.
Press START to display
model plug #.
Slow Spin Test
Activates 150 rpm spin.
Press START to display
rpm.
Fast Agitate Test
Activates 155 spm
agitate.
Slow Agitate Test
Activates 30 spm
agitate.
Press
CUSTOM 2
Press
CUSTOM 2
Press
CUSTOM 2
Press
CUSTOM 2
Press
CUSTOM 2
Water Valve Test
Opens hot water
valve.
Water Valve Test
Opens cold water
valve.
Press
CUSTOM 2
Press
CUSTOM 2
Lid Switch Test
Displays lid switch
state (OPn, CLS).
Press
CUSTOM 2
Pump Test
Activates Pump.
Displays P and
tenths of Amp.
Press
CUSTOM 2
Press
CUSTOM 2
Press
CUSTOM 2
Press
CUSTOM 2
Inverter Test
Applies power inverter.
Press START to cycle
inverter communication
lines between J2 pins 4
and 5.
Press
CUSTOM 2
Accelerometer Test
Displays radial
acceleration upon entry.
Press START to view
vertical acceleration.
Press
CUSTOM 2
Press
CUSTOM 2
Water Temperature Test
Displays water sensor
temperature.
Press
CUSTOM 2
Press
CUSTOM 2
To Next Page
Loading...
