– 40 –
Error Codes
Refer to the steps below to check error codes. Refer to the Error Codes Table for a listing and
description of all error codes and the procedure to correct the error.
To check error codes:
1. Enter Service Mode.
2. Index to the Error Codes function using the CUSTOM 1 pad.
• If no errors are present, E00 will be displayed on the DSSD.
• If an error code is present, the error code will display immediately. If there is more than one
error, pressing START will clear the displayed error code from the fault log and cause the next
most recent error to be displayed.
To clear all error codes, continue to press the START pad while in the Error Codes function.
Note: Clear all error codes before exiting service mode
Error Codes
To Next Page
Loading...
