– 39 –
Wire Harness
The wire harness is replaceable in two sections. The
upper harness:
And lower harness:
Upper Harness Replacement
1. Remove the control panel and control board
and rear component cover.
2. Raise the top and pull the harness through the
front opening, removing it from the harness
support clips on the underside of the top cover.
3. After disconnecting the components at the rear
of the washer, pull the harness through both
openings at the rear of the top cover.
4. Remove the back panel. Unclip the harness from
the cabinet.
To Next Page
Loading...
