[] Leveling the Range
[] Install the oven shelves in the o_en and
position the range where it will be installed.
[] Check tot levelness by placing a spirit level or
a cuI), partially filled with water; on one of the
oven shelves. If using a spirit level, take two
readings--with the level placed diagonally
fi_t in one direction and then tile other:
[] Remo_e the storage drawer or wam/ing
drawer; See tile Careand cleaning of the range
section. The ti'ont leveling legs can be a(!iusted
fl'om the bottom and the rear legs can be
a(!itlsted ti'OIll the top or the bottoi/l.
[] ILrsing an open-end or a(!iustable wrench,
a(!itlSt the lexeling legs tmfil tile range is lexel.
[] _Mter the ran,*e,_ is level, slide the range away
fl'om the wall so that the Anti-Tip device
can be installed.
Raise
range
(on some models)
Lower
range
(on some models)
45
To Next Page
Loading...
