Installationof the range.
[] Installing the Anti-Tip Device
WARNING:
Range must be secured with an approved
Anti-Tip device.
Unless properly installed the range could be
tipped by )ou or a child standing, sitting or
leanino_ on an open (looi:
_Mier inst;flling tile Anti-Tip dexice, xefi 6' that
it is in place b) carefillly attempting to tilt the
range fin'ward.
This range has been designed to meet all
recognized industry tip st;mdards fin" all
noIII/al conditions,
The use of this device does not l)reclude
tipping of tile range when not properl)
installed.
If tile Anti-Tip dexice suI)plied with tile range
does not fit this application, use tile uni'_ei_al
Anti-Tip device X_B02X7909.
[]
Mark tile wall where tile RIGHT EDGE of tile
range is to be located. Be sure to allow fin" tile
cotmtertop overhang if wm intend to install
tile range next to cabinets.
_ devAnti-]]PI
ice ]
___..I
Slottedheadscrew _U q_'_
rr:lwa'','a,eI
o I
/ // Markededgeof range
[] I,ocate the outside edge of the de_ice 2_"
toward the center of the range ti'om the
marked edge of the range.
[] Using tile device as a template, mark tile
position of the hole fin" the screw.
[] For wood construction, drill a pilot hole at an
angle of 20 degrees fl'om the horizontal. A nail
or awl mm be used if a (11111is not axailable.
Mount tile Anti-Tip device with tile screw provided.
For celllent oi" conci"ete constrtiction, veil
will need a 1/4" x 1_" lag bolt and a 1/2" O.D.
sleeve anchm, which are not provided. Drill
tile recommended size hole fin" tile har(Mare.
Wallboard
Backof range
Antb]]p
device
Install tile sleeve anchor into tile drilled hole and
then install tile lag bolt through tile device. Tile
bolts must be properly tightened as recommended
fin" tile hardware.
[] Slide tile range against tile wall, and check fin.
proper installation 1)1',_orasi)ing, tile ti'ont edoe
of tile cooktop and careflllly attempting to tilt
tile range forward.
When All Hookups Are Completed'.
MAKESUREALLCONTROLSARELEFTIN THEOFF
POSI770N.
MAKESURETHEFLOWOFCOMBUSTIONAND
VENTILAtiONAIRTOTHERANGEISUNOBSTRUCTED.
46
Converting to LP Gas (or converting back to natural gas from LP)
Thisrangeleavesthefactoryset forusewithnaturalgas.
Ifyouwanttoconvertto LPgas,theconversionmustbe
performedbya qualifiedLPgasinstaller
Kee I) these instructions and tile orifices in case xou
want to co11"_ei1 back to natt11"al gas.
Tile conveision instructions and I,P orifices can be
fi)und attached to the ranoe_ next to the pressure
regulatm;
To Next Page
Loading...
