Beforeyoucall forservice...
Troubleshooting -tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
GEAppliances.com
Possible Causes What To Do
Topburnersdo not light Plug on range is slot completely * Make sure electrical plug is plugged iuto a live, properly
or do not burn evenly inserted in the electrical outlet, grotmded outlet.
Burner holes on the side or * Remove the burueis (on models with standard twin
around the top of the burner buruels) or buruer heads (ou Iuodels with sealed
may be dogged, buI'ueis) or burner caps on spill-l)roof models, and clean
them with a sewing needle or twist-tie. Make sure you do
not enlarge the holes. On spill-proof models, check the
electrode ;ll'e;i t0f btli'ued-ou t0od of gI'e;ise.
Improper burner assembly. * Make sm'e the drip pans are installed correctly.
See the Care and cleaning of the range section. "
Burner flames very Improper air to gas ratio. * If range is conue('ted to l.P gas, coutact the persou
large or yellow who installed your l';lIlge of made the conversion.
Surface burners light The oven gas shut-off valve * To check the oven gas shut-nit valve, remove the
but oven does not may have accidentally been storage drawer (see the Care and cleaning of the range
moved during cleaning or section) and look for the gas shut-off lever at the
moving, back of the range.
Leveris
shownclosed.
PULLTOOPEN.
Fluorescenttoplight
doesnotwork
Fluorescent bulb is loose
or defective.
Switch operating the light
is broken.
• Ac!iust or replace.
• Call fin" service.
47
To Next Page
Loading...
