GEA Bock HGZ Series - Installation Example, Liquid Subcooler With Accessories

D
GB
F
E
17
09726-09.2013-DGbF
1 Liquidsubcooler 5 Expansionvalve FUA liquidsubcooler,
2 Filterdrier 6 temp.sensorexpansionvalve Outlet
3 Solenoidvalve 7 Pressurecompensationconnection FUE liquidsubcooler,
4 sightglasses Inlet
INFO! General notes:
Sensorlines,wires,etc.shouldnotbeattachedwithcablebinders
directlytopipesorframes;otherwise,thethinpipesmaybeworn
through. It is better to run them through spiral protective tubes.
Ifthecompressorwillbesetupoutside,UV-resistantmaterials
should be used.
Ø16mm
Ø16mm
Ø16mm
Ø16mm
Ø6mm
Ø12mm
Ø12mm
Ø12mm
FUE
MitteldruckkammerMP
Wärme-
dämmung
Fig.20
5| Compressor assembly
5.3 Installationexample,liquidsubcoolerwithaccessories
Dia.16mm
Dia.12mm
Heat
insulation
fromthereceiver
totheevaporator
Line A
Line B
Line B
Dia.16mm
Dia.16mm
Dia.6mm
Dia.12mm
Dia.12mm
Dia.16mm
Intermediatepressure
chamberMP