EN
Rectifying malfunctions
Fault Cause Action
Unable to
activate the
pressing tool out
of idle state and
no LEDs are lit.
Rechargeable battery
is defective.
▶ Replace the rechargeable battery with a
Geberit lithium-ion battery of type
Milwaukee12V
.
▶ Have the defective rechargeable battery tested
by an authorised repair shop.
The rechargeable
battery has not been
inserted properly.
▶ Insert rechargeable battery.
Pressing tool is
defective.
▶ Have the pressing tool inspected by an
authorised repair shop.
Green LED
flashes.
Rechargeable battery
not charged up suffi-
ciently.
▶ Charge the rechargeable battery or replace it
with a Geberit lithium-ion battery of type
Milwaukee12V
.
Retaining pin has not
been inserted
correctly.
▶ Insert the retaining pin.
Retaining pin has
come loose.
▶ Insert the retaining pin.
▶ Check the pressing operation and repeat if
necessary.
Red LED
flashes.
Incorrect or defective
rechargeable battery
inserted.
▶ Replace the rechargeable battery with a
Geberit lithium-ion battery of type
Milwaukee12V
.
Pressing tool is
outside of the
operating
temperature.
▶ Observe operating temperature of the
rechargeable battery.
Red LED lights
up.
Device failure
▶ Press the start button. If pressing the start
button is not successful, the pressing tool is
defective. Have the pressing tool inspected by
an authorised repair shop.
▶ Check the pressing operation and repeat if
necessary.
The pressing tool
stops and no
LED lights up.
Rechargeable battery
is defective.
▶ Release start button.
▶ Replace the rechargeable battery with a
Geberit lithium-ion battery of type
Milwaukee12V
and have it inspected by an
authorised repair shop.
▶ Press and hold release button: roller drive
moves to its starting position.
▶ Check the pressfitting for tightness and repeat
the pressing operation if necessary.
Red and green
LEDs flash
alternately.
Maintenance interval
has been reached.
▶ Have the pressing tool inspected by an
authorised repair shop.
30
27021599660551563-1 © 02-2021
968.403.00.0(01)
To Next Page
Loading...
