Geberit ACO 103PLUS - Cleaning and lubricating the Geberit pressing tool

EN
Cleaning and lubricating the
Geberit pressing tool
WARNING
Risk of injury from switching on
inadvertently
▶ Remove the rechargeable
battery before starting any
maintenance work on the
pressing tool.
ATTENTION
Damage to the device from moisture
▶ Never clean the pressing tool with
water or other liquids.
1 Push in both release buttons on the
rechargeable battery and pull it out.



2 Clean the roller drive, roller drive
guide and retaining pin of the
pressing tool.
3 Use a brush to remove dirt.
CAUTION
Harmful substances
▶ Observe the safety notes of
the lubricant used.
4 Lubricate the roller drive, roller drive
guide and retaining pin with
BRUNOX®
Turbo-Spray®.
5 Wipe away excess lubricant using an
absorbent cloth.
32
27021599660551563-1 © 02-2021
968.403.00.0(01)