EN
9007212209767563 © 01-2024
972.178.00.0(00)
31
5 Push the ends of the jaw levers together and remove the
Geberit pressing jaw from the Geberit pressfitting. Check the
pressing contour.
If a press connection has not been completely pressed – in
the event of a power cut, for example – it must be pressed
again. Corrective pressing is performed in the same way as
a normal pressing operation. Depending on the state of the
preliminary pressing, there may be considerable idle stroke
before the pressing tool engages during corrective pressing.
To Next Page
Loading...
