Geberit HDPE - Electrofusion Coupling (Pipes Ø 40-160 mm)

21
Jointing methods
Geberit Drainage Systems
4.2.1 Electrofusion coupling
(for pipes Ø 40 to 160mm)
A Geberit Electrofusion machine ESG 40/200
(240V) or Advance Welding AW315G (110V)
electrofusion machine must be used.
1 Insert pipe or fitting
ends into the sleeve
coupling up to
insertion depth mark.
B.500.000/192
3 cm
3 cm
2 Connect
electrofusion
machine, start
welding procedure.
Welding time
approximately 70 –
90 seconds.
3 After the ‘end’
indicator has turned
on, remove the
connection cable.
The protruding
yellow indicator
shows whether the
welding process was
performed correctly.
4 If required for sake
of appearance,
the electrical
connector socket on
electrofusion
couplings (diameters
Ø 40 to 160mm)
can be removed
after the end of
installation work.
Geberit Electrofusion
machine ESG 40/200
B.360.771/001
Electrofusion
sleeve coupling
Correct
Incorrect
✘
✘
3