What to do if nothing works on my Gecko MSPA-1-AS?
If nothing is working, verify the input supply wiring. You can also try replacing the transformer fuse (F6), cleaning the pins of the transformer orange connector using a screwdriver, or replacing the transformer or the board. If these steps don't resolve the issue, call an electrician.
Why is my Gecko MSPA-1-AS not heating?
If your spa isn't heating, first ensure that the temperature set point is higher than the current water temperature. Additionally, you can use foam to insulate the probe, replace the temperature probe, replace the heater.
What to do if the blower does not work on my Gecko MSPA-1-AS Spa Accessories?
If the blower isn't working, you can replace the blower, replace the blower fuse (F7), or create an opening to let more air reach the blower.
How to fix a spa light that does not work on Gecko MSPA-1-AS Spa Accessories?
If the spa light isn't working, you can replace the light bulb, replace the spa light socket, or replace the light fuse (F1).
What to do if the ozonator does not work on my Gecko Spa Accessories?
If the ozonator isn't working, you can replace the ozonator, or replace the ozonator fuse (F3).
What to do if keys do not work on my Gecko Spa Accessories?
If the keys aren't working, you can replace the top side control by a spare one, or replace the defective top side control.
Troubleshooting guide for the "FLO" message related to pressure switch issues.
Troubleshooting guide for the "FLC" message indicating a pressure switch problem.
Troubleshooting guide for the "Prr" message indicating a temperature regulation probe issue.
Troubleshooting guide for the "HL" message indicating a high-limit sensor issue.
Troubleshooting steps for when the system is connected but nothing seems to work.
General| Model | MSPA-1-AS |
|---|---|
| Category | Spa Accessories |
| Manufacturer | Gecko |
| Voltage | 120V |
| Material | Plastic |
To Next Page
