Need help?Do you have a question about the Geeetech GT2560 and is the answer not in the manual?
General| Microcontroller | ATmega2560 |
|---|---|
| Input Voltage | 12-24V DC |
| Operating Voltage | 5V |
| USB Interface | USB Type B |
| Firmware | Marlin |
| Supported File Format | G-code |
| Connectivity | USB |
| Fan Outputs | 2 |
| Endstop Connectors | 6 |
| Digital I/O Pins | 54 |
| PWM Pins | 15 |
| Analog Input Pins | 16 |
| Flash Memory | 256KB |
| SRAM | 8KB |
| EEPROM | 4KB |
| Clock Speed | 16MHz |
| Heater Outputs | 2 |
| Step Drivers | A4988 / DRV8825 |
Explains how to configure stepper motor subdivision for A4988 drivers using jumper caps.
Step-by-step guide for installing the FT232RQ USB serial driver on Windows.
Instructions for uploading firmware via Arduino IDE, including selecting the correct board type.
Guides on uploading Marlin firmware and setting critical parameters like baud rate and motherboard.
Configuring temperature sensors, extruder limits, and endstop inversion for optimal performance.
Setting homing direction, axis position limits, and homing feedrate for accurate printing.
To Next Page